Agate tipped burnisher with bamboo handle. Use to create a high shine on finished silver and to attach gold foil to heated silver (Keum Boo technique).

Pure fine silver wire - 12 inches 18g round, dead soft.

Pure fine silver wire - 12 inches 20g round, dead soft.  This is the wire you need to attach freshwater pearls with!

Sulfurated potash. Use as a patina to give color or an antiqued look to precious metal clay Silver pieces. (8oz.) Dry chunks in a sealed, plastic bottle.  Keep in cool, dry place.

This package contains 9 different grits on 2" x 2" pads. These flexible pads work great with both pre-fired and post-fired pieces of Art Clay. Grits include 1500, 1800, 2400, 3200, 3600, 4000, 6000, 8000, & 12000.   Now color coded!

Set of 12 carbon steel files (5.5" long each) Assorted shapes. Keep dry.

A 10 pack of 4"x4" reusable non-stick work surfaces. Can be placed in drier, but not kiln.

Heat softened molding material. Reusable. (1.4oz)
Directions: Dip the Oyumaru into hot water (more than 176ºF) for 3 minutes. Take the Oyumaru out of the water with a pair of tongs and wipe it dry with a towel. While it is still soft, press the material you wish to mold into the Oyumaru. If the Oyumaru gets hard while you are working with it, place it back in the water and beging the process again.

High quality, lint free, polishing cloth. (14cm x 9cm)

Set of 4 different grits of clothlike sandpaper 400, 600, 1200, and 4000. Sheets are 4.25" x 5.5" and have grit on one side. Use dry before firing, wet after firing. Rinse out and use over and over. Great for both pre-fired and post-fired pieces!

This package contains 9 different grits on the ends of 2.25" long swabs. These swabs are great for getting in the little areas that need a little touching up. Grits include 1500, 1800, 2400, 3200, 3600, 4000, 6000, 8000, & 12000.

*  Plastic Roller

*  Plastic Strips

*  Mini File Set

*  Flat Paint Brush

*  Fine Pointed Paint Brush

*  Spatula

*  Clean-up Tool

*  Adjustable Ring Sizer

*  Stainless Steel Brush

*  Bamboo Skewer

*  Craft Knife

*  Cutter Scraper

All tied up in an ACW Fabric Tool Roll!

Simply mix this new solution with metal clay to create a flexible, textured sheet.  Maximum flexibility is achieved by firing at 1650F for two hours.  Metal Clay Veneer cannot be used on rubber based products.

This product must be kiln fired!